最新の1Y0-740問題集で試験を準備する

Citrix 1Y0-740 試験概要:

Citrix 1Y0-740 試験シラバストピック:

Citrix WANScaler 4.2: Administration 認定 1Y0-740 試験問題：

1. In an environment where two sites are connected by a point-to-point circuit and partial bandwidth is enabled, which acceleration mode will be supported?

A) Hardboost
B) Inline
C) Partial
D) Full bandwidth

2. Scenario: An administrator is performing an analysis of the WANScaler Usage Graph in an attempt to diagnose packet loss. It is apparent that there is a difference between the accelerated throughput and the accelerated line usage. The administrator may determine the source of the issue in the __________ WANScaler Usage Graph. (Choose the correct option to complete the sentence.)

A) receiver LAN-side
B) sender LAN-side
C) receiver WAN-side
D) sender WAN-side

3. An administrator configures group mode such that a single WANScaler will continue to accelerate traffic in the event a partner WANScaler goes offline.
If a partner unit in this group mode configuration is unable to pass traffic because it is offline, the fail to wire (FTW) card will __________ and the router port upstream of the failed WANScaler will then be __________. (Choose the correct option to complete the sentence.)

A) fail closed; marked up
B) fail closed; marked down
C) fail open; marked up
D) fail open; marked down

4. Scenario: An administrator creates a service class to match HTTP traffic on a local subnet.
Following a recent increase in HTTP activity, the administrator wants to review the statistics for this service class. Which type of information can the administrator obtain from the Monitoring Service Class Statistics page for the HTTP service class?

A) Total compressed bytes
B) Total uncompressed packets
C) Total unaccelerated packets
D) Total accelerated bytes

5. Scenario: A System Administrator is attempting to configure a QoS solution for a routine file transfer that is critical to the organization. The file is transferred using FTP and it is important that no other traffic suppresses the transfer to less than 20% of the bandwidth limit. In addition, all queues must be named appropriately. Which three steps should the administrator take to meet the requirements of this scenario? (Choose three.)

A) Change the bandwidth allocation of "Queue B" from 0% to 20% and change the bandwidth allocation of "Queue A" from 100% to 80%.
B) Assign the "FTP" queue, in megabytes, 20% of total available bandwidth.
C) Change the bandwidth allocation of "Queue A" from 0% to 20% and change the bandwidth allocation of "Queue B" from 100% to 80%.
D) Change the name of Queue B to "FTP."
E) Create a queue and name it "FTP."
F) Update the FTP Data service class QoS from "Queue A" to "FTP."

質問と回答：