最新のNSE5_FNC_AD-7.6問題集で試験を準備する

Fortinet NSE5_FNC_AD-7.6 試験概要:

Fortinet NSE5_FNC_AD-7.6 試験シラバストピック:

Fortinet NSE 5 - FortiNAC-F 7.6 Administrator 認定 NSE5_FNC_AD-7.6 試験問題：

1. Which group type can have members added directly from the FortiNAC Control Manager?

A) Port
B) Administrator
C) Device
D) Host

2. An administrator has created several device profiling rules and evaluated all existing devices in the database. Some of the devices appear in the profiled devices view because they matched a rule, but they remain unknown and the registration column in the profiled devices view shows
"No".
What is the most likely cause?

A) The device profiling rule has registration set to manual.
B) The devices match more than one device profiling rule.
C) The devices have persistent agents installed, and the point of connection has PA optimization enabled.
D) The confirm device profiling rule option is not enabled.

3. When configuring isolation networks in the configuration wizard, why does a layer 3 network type allow for more than one DHCP scope for each isolation network type?

A) Any scopes beyond the first scope are used if the initial scope runs out of IP addresses.
B) Configuring more than one DHCP scope allows for DHCP server redundancy
C) There can be more than one isolation network of each type
D) The layer 3 network type allows for one scope for each possible host status.

4. Refer to the exhibit.

An administrator is configuring FortiNAC-F for the onboarding of guest users.
Which IP address would be used for the gateway defined in the DHCP scope?

A) 10.0.1.110
B) 10.0.1.254
C) 10.20.1.250
D) 10.10.1.250

5. During the testing of a newly modeled infrastructure switch, the administrator is not seeing hosts as they connect or move from one port to another.
What would cause this issue?

A) The default scheduled polling is disabled.
B) Layer 3 polling is failing.
C) MAC notification traps are misconfigured.
D) Contact polling is not configured.

質問と回答：