最新のGB0-341-ENU問題集で試験を準備する

When using the PEAP or EAP-TLS wireless authentication method, we need to use which command to enable it globally, and load the root certificate and server certificate as needed.

• A. dot1x authentication-method chap
• B. dot1x authentication-method pap
• C. dot1x authentication-method eap
• D. dot1x authentication-method peap

What are the several important driving forces of WLAN market demand? (Multiple choice)

• A. Easy to manage
• B. Economical
• C. Efficient
• D. Degree of freedom

Which of the following statements are correct about wireless network roaming? (Multiple choice)

• A. In the case of Layer 3 roaming, the controller AC is needed to realize the inheritance of VLAN information, so the FAT fat AP scenario does not support Layer 3 roaming.
• B. When STA roams between different APs, the network side needs to ensure that the IP address, VLAN information, etc. remain unchanged
• C. The roaming handover is finally initiated by the STA, and the STA will comprehensively weigh whether it needs to initiate roaming according to the signal strength and link quality.
• D. Some terminals will automatically switch to other SSIDs when the current SSID link quality is poor. This is also roaming. As long as different SSIDs are managed by the same AC, the service will not be interrupted.

Which of the following statements about indoor PAP installation specifications is correct? (Multiple choice)

• A. The AP must be firmly fixed during installation, and it is not allowed to be placed in the air; the installation location of the AP must have enough space for heat dissipation, debugging and maintenance of the equipment.
• B. The hoistway, floor, wall, etc. of the installation location must not seep water, have low dust, and have good ventilation. The installation location must ensure that there are no strong electricity, strong magnets and corrosive equipment. The temperature and humidity of the installation location must not exceed the host. The placement must be good. Lighting conditions to facilitate equipment maintenance and repair
• C. When the AP is installed in a weak current well, safety measures such as dust-proof, waterproof and anti-theft should be taken, and the working environment should be well ventilated and clean; when the AP is wall-mounted on the wall of the building, anti-theft measures must be taken; When the AP is installed on the ceiling, it must be fixed with a fixing frame. It is not allowed to be placed in the air or thrown directly on the ceiling. The installation location should be close to the access opening.
• D. The AP installation location must meet the engineering design requirements. If the AP installation location needs to be changed, the approval of the design unit and the construction unit must be obtained, and the design change procedures must be completed.

If a wireless local area network only contains STA, this kind of network structure has a special name in the 802.11 network, this name is?

• A. IBSS