最新のH12-841_V1.5問題集で試験を準備する

Huawei H12-841_V1.5 試験概要:

Huawei H12-841_V1.5 試験シラバストピック:

Huawei HCIP-Datacom-Campus Network Planning and Deployment V1.5 認定 H12-841_V1.5 試験問題：

1. In Huawei's WAN bandwidth management solution, which of the following functions can "limit the bandwidth usage of non-critical services such as P2P downloads and ensure the bandwidth of core services (such as ERP)"?

A) Allocate bandwidth quotas for core services, without limiting them to non-critical services.
B) Shut down non-critical services and only allow core services to access the network.
C) All services are allocated the same bandwidth, without any priority distinction.
D) Application-based bandwidth limiting policies (P2P services are limited, core services are guaranteed bandwidth)

2. In the wide area network IPv6 transition scenario, if "internal IPv4 and IPv6 terminals need to communicate with each other", which of the following technologies should be adopted?

A) DNS64+NAT64 (only enables IPv6 terminals to access IPv4 resources)
B) IPv4/IPv6 dual-stack technology (terminals support both protocols simultaneously, enabling direct interoperability).
C) IPv6 over IPv4 tunnel (only enables communication between IPv6 terminals)
D) NAT444 (only performs IPv4 address translation)

3. In Huawei's WAN bandwidth management solution, which of the following functions can "limit bandwidth for non-critical services such as P2P downloads and online video to ensure the performance of core services such as ERP and VoIP"?

A) Prioritize bandwidth allocation for non-critical services; allocate bandwidth for core services as needed.
B) Shut down non-critical services and only allow core services to access the network.
C) All services are allocated the same bandwidth without any restrictions.
D) Application-type-based bandwidth limiting policy (limiting bandwidth for non-critical services)

4. In an MPLS VPN network, after a PE device learns a route from a CE device, which of the following operations can "convert the route into a VPNv4 route and advertise it to other PE devices"?

A) No configuration is required; the PE device automatically converts and publishes routes.
B) Configure routing policies on the PE device to import CE routes into the BGP VPNv4 address family.
C) Configure BGP VPNv4 neighbor on the P device to pass routes.
D) Enable the MPLS protocol on the CE device and directly advertise VPNv4 routes.

5. In Huawei's SD-WAN solution, which of the following functions can "monitor the operating status of branch devices (such as link latency and packet loss rate) in real time and generate performance reports"?

A) Network performance monitoring and reporting
B) Root Cause Recommendations
C) Configure version management
D) Equipment hardware failure alarm

質問と回答：