Avaya Ethernet Routing Switch Implementation 認定 6101-1 試験問題:

1. Where is the rate-limit feature of the Converged Campus architecture limited?

A) inter Switch Trunk ports on the core switches
B) uplink ports on the edge switches
C) access ports on the edge switches
D) uplink ports on the core switches

2. A technician is configuring 802.1 Q tagging, VLACP with short timeout, untagged frames to be discarded.
Which part of the network is being configured?

A) layer 3 core
B) layer 2 core
C) the uplinks
D) the edge

3. One of the switches in the Ethernet Routing Switch (ERS) stacks files and is replaced.
The auto unit replacement (AUR) is enabled but the stack is not functioning properly.
What is the problem?

A) the stack power was left on during the switch replacement.
B) The stack has two switches with Force Stack disabled.
C) The switches in the stack are not identical
D) The switches in the stack are not running the same release of software

4. A technician is configuring an Ethernet routing switch (ERS)-24T-PWR, and to add ports 10 through 20 to VLAN 100.
Which ACLI command is used to accomplish this task?

A) 5520-24-PWR (config) # vlan 100 add members 10-20
B) 5520-24-PWR (config) # vlan members add 100 10-20
C) 5520-24-PWR (config-vlan) # members add 100 10-20
D) 5520-24-PWR (config-if) #vlan 100 add members 10-20

5. Avaya recommends using RSMLT edge in place of VRRP with Backup Master, when available what are two valid reasons for using RSMLT edge? (Chouse two)

A) RSMLT edge provides support for application where more than 255 redundant default gateways (VRRP limit) need to be provided.
B) the VRRP hold down timer cannot be set high enough to update the complete routing table when Layer 2 access requirements are high.
C) RSMLT edge allows the cluster to be configured to discard untagged frames in 1ST and SMLT ports.
D) RSMLT edge is easier to configure and lightens the CPU load,
E) RSML T dynamically balances the CPU load across the switch cluster.

質問と回答：