IBM Security Network Intrusion Prevention System V4.3 Implementation 認定 C2150-561 試験問題:

1. What is the maximum network throughput that IBM Security Network Intrusion Prevention System V4.2 can support?

A) 10G
B) 4G
C) 23G
D) 8G

2. An administrator has reimaged an IBM Security Network Intrusion Prevention System V4.3 (Network IPS) without unregistering it from IBM Security SiteProtector System (SiteProtector) and has reconfigured it identically. It has resulted in duplicate agents listed in the Agent view in SiteProtector with one of them in offline status. Why?

A) SiteProtector uses the agent name to recognize the Network IPS device and when the name changes it is registered as a new device.
B) When an agent heartbeats in, it will register the device as a new agent even if SiteProtector has already registered it.
C) When an agent heartbeats in, SiteProtector does not check to see if the agent already exists before adding it as an agent.
D) SiteProtector uses an agent GUID to recognize Network IPS devices and when this GUID changes it is registered as a new device.

3. What is the most efficient process to restore an appliance configuration back to factory default?

A) use the built-in recovery boot manager
B) from Appliance Management in the Configuration menu, recover the configuration from a backup while logged in locally as root
C) perform a factory restore using a USB flash drive
D) perform a factory restore using a laptop as a PXE boot server

4. Where can the state of the High Availability configuration be checked in IBM Security SiteProtector System?

A) on the Agent Messages tab
B) on the Health Summary Security tab
C) the Status field on the Agent tab
D) the agentinfo section under Module Status

5. The IBM Security Network Intrusion Prevention System V4.3 is not registering with IBM Security SiteProtector System (SiteProtector). Where in the Local Management Interface (LMI) can potential connection issues be corrected?

A) Select Telnet under System Tools and telnet to the Agent Manager IP using port 3995.
B) If the SiteProtector Management option was selected during the initial installation, SiteProtector communications settings cannot be changed in the LMI.
C) Under Management and TCP Reset Interfaces, check to see that both ports 443 and 3995 are enabled.
D) On the SiteProtector Management page, confirm Register with SiteProtector has been selected and review the Agent Manager Configuration settings.

質問と回答：