HP Implementing HP Network Technologies 認定 HP0-Y46 試験問題:

1. Which statements are correct about HP StoreOnce Backup? (Select two.)

A) It provides high-speed data backup using a 3U rack enclosure with multiple tape arrays.
B) It transfers only unique data across the network and stores it on the remote backup devices.
C) It reduces bandwidth and storage media use with deduplication technology.
D) It is a modular, branch-in-a-box solution that reduces the cost of remote installations
E) It provides long term data retention using tape backup libraries with LT0-6 technology.

2. A network administrator is examining the routing table on an HP Comware switch. The network administrator sees two routes. 10.1.1 0/24, with the same neighbor's address (10.1.1.1). What would create this result?

A) The bandwidth of the two routes is the same.
B) The cost of the two routes is the same.
C) There is an aggregated link with two connections between the two routers.
D) The administrative distance of the two routes is the same.

3. Which standards do HP products support for Power over Ethernet (PoE)? (Choose Two)

A) 802.3at
B) 802.1ah
C) 802.3av
D) 802.1az
E) 802 3af

4. A network administrator is setting up OSPF between an HP Provision and HP Comware switch. Once the configuration is finished, the network administrator sees log messages in the Comware session about the successful establishment of the adjacency. However, the network administrator does not see similar messages on the Provision console.
How can the network administrator see these log messages about the new OSPF adjacencies on the Provision console?

A) Use the terminal monitor command.
B) Use the show event-log command.
C) Use the terminal logging command.
D) Use the show logging command.

5. A network administrator receives a new HP Provision switch and notices that the software version running on the switch is older than what is currently used in the network. The network administrator copies an updated version of the operating system from the new switch's USB port to the secondary flash location. The network administrator then executes the following command:
ProVision # boot system flash secondary
The switch reboots using the new operating system. However, when the network administrator turns off the switch and turns it back on, the switch boots from the old operating system. Which solution should the network administrator use to fix the problem?

A) Execute the startup-boot secondary command
B) Execute the boot set-default flash secondary command.
C) Execute the startup-default secondary command.
D) Execute the boot-loader file command.
E) Boot into the switch's Monitor ROM Console and perform the upgrade a second time.

質問と回答：